The Kit Plastica dos Fios Thermal Sealing is an intensive treatment that reduces the volume, eliminates frizz and provides straight and controlled hair strands for up to 3 months. It nourishes and hydrates deeply the strands besides giving an incredible shine and strengthen the structure, avoiding the breakage.
Cadiveu Plastica dos Fios Step 1 Pre-Sealing Shampoo 1000ml: Deep cleans the hair strands and helps to open the cuticle facilitating the penetration of the active ingredients of the treatment.
Cadiveu Plastica dos Fios Sealing Thermal Step 2 - 1 liter: With the other products, promotes the natural straight effect of long duration in the hair strands and leaves the hair shiny and frizz-free.
Cadiveu Plastica dos Fios Step 3 Sealant Mask 1000ml: Promotes the maximum hydration of the hair reducing frizz and accentuating the straightening effect.
Treatment consisting of Arginine, Acai Extract and Acetic Acid (acid ph).
Acai Extract: rich in nutrients such as Vitamins, Essential Sugars and Emollient Oils. Its antioxidant and protective action promotes a complete regeneration of the hair strands, hydrating them in an efficient and prolonged way.
Amino Acids: balance the structure of the hair strands of the aggressions caused by the excessive use of dryers and flat iron. Increases its malleability and elasticity, leaving the hair smoother and extremely easy to comb.
Phytonutrients: Nourishes and protects the hair strands, helping to regenerate damaged and worn parts.
Acetic Acid Shampoo: because it has an acidic pH, it can cause irritation and peeling on sensitized leather. For this reason we recommend not to apply to pregnant women, people with sensitive scalp and children up to 12 years.
Note: Provides approximately 35 applications. Certified Micro Quality Labs (USA) and by Anvisa. The effect is prolonged with the use of maintenance products Plastica dos Fios.
It should not be applied on pregnant women, people with sensitive scalp and children.
Try Cadiveu - Plastica Dos Fios Keratin Treatment Box Kit 3x1L and check the results.
Required material: silicone gloves, dryer, flat iron, plastic clips, fine comb, brush and plastic container.
1- Wash your hair with the Pre-Treatment Shampoo, massaging it until it forms a foam. Wash twice in case of virgin, very resistant or very dirty hair. Leave on for 5 minutes and rinse thoroughly. Warning: do not rub the scalp.
2- Dry the hair in 80% with the dryer and the help of the fingers.
3- Separate the hair in 6 parts (a vertical line separating the hair in two locks- right and left - and 3 horizontal sessions - nape, middle and front from the ears). Tie each session into a bun with a clip.
4- Pour 20 to 40ml of the Thermal Seal in a container and put on the silicone gloves.
5- Begin to apply in a session of the nape of the neck with the help of the brush. Apply two fingers of the root to the base of the session and pull the product to the tips with the comb. Make sure the product is on all strands.
6- Repeat the procedure with the session on the side.
7- With the dryer in the cold jet, dry the two sections in 100%. It is important to dry two sessions at a time with the cold jet. This prevents the formation of smoke and prevents the product from evaporating without having any effect.
8- Repeat the procedure from 5 to 7 in the two central sessions of the hair, one at a time.
9- Finally, repeat the procedure from 5 to 7 in the two frontal sessions of the hair, drying the strands backwards. It is important that neither the wind of the dryer nor the session with the product come into contact with the face.
10- Time to straighten! In blonde, damaged or chemical hair, the temperature of the flat iron should not exceed 200°C. On normal, virgin or temperature resistant hair, the temperature should be 230°C.
11- Divide the hair again into parts using hair clips. Separate a thin and linear session and straighten the length (without the ends) of the session 10 times ( flat iron at 200°C) or 7 times ( flat iron at 230°C).
12- Straighten the ends (without the length) of the hair up to 4 times ( flat iron at 200°C) or 2 times ( flat iron at 230°C). In this way you avoid the artificial straight effect on the ends.
13- Repeat this process (step 11 and 12) for all hair sessions. The flat iron straight to the scalp naturally straightens the strands from the root.
14- After all sessions, rinse the hair well.
15- Apply the Restorative Mask on the strands, gently massaging the strands. Leave it on for 5 minutes and rinse again.
16- Dry the hair with the dryer.
Note: In the case of relaxed or straightened hair, apply the Plastica dos Fios Thermal Sealing after the chemical process. In case of color tinting or tonalization, apply the Plastica dos Fios Thermal Sealing two days before or after the color tinting, to better fix the color pigments in the strands.
We recommend that you use this treatment with the help of a professional.
Tip: For best results use together with the rest of the line Plastica dos Fios.
Naturally straight, frizz-free, stronger, repaired hair with incredible shine for up to 3 months!